![hp smart array p410i controller driver windows 2008 r2 hp smart array p410i controller driver windows 2008 r2](https://i.imgur.com/KRBlMqD.jpg)
![hp smart array p410i controller driver windows 2008 r2 hp smart array p410i controller driver windows 2008 r2](https://i.ytimg.com/vi/njdtIT8OfR8/maxresdefault.jpg)
It is NOT POSSIBLE to boot off the HP p410 here! Install the desired OS onto your system HD which HAS TO BE connected to onboard or another controller (in my case the LSI). You will NOT see ANY message from the HP controller when booting! That is because you've configured the PCIe slot ROM option to disabled - and that is exactly what we wanted. (I've put the LSI card into Slot 6 (the one below), with enabled Boot ROM - Reason: I want an external card that runs HW RAID1 (flashed it to IR Firmware)) Remove the Boot ROM card from slot 7 and put in the HP p410 into this slot Boot into the BIOS and under "PCI/PCIe" settings, set the Option ROM to "Disabled" Don't put the HP p410 into any slot of the board Put a card with Boot ROM (in my case my LSI controller) into the topmost slot (7)
Hp smart array p410i controller driver windows 2008 r2 how to#
Here's a workaround how to get this combination to work*: I've spend some hours last night playing around with the board and both controllers. Don't get me wrong, I can live with mdadm, but HW RAID would be "nicer". Of course - I would love to use the HP RAID controller, but I've the bad feeling that it's incompatible with my board - or am I wrong? Maybe one of you give me a hint. Yesterday, my HP SAS Expander (green) arrived and luckily this one works very well with my "old" LSI/Intel SASUC8i (IT Firmware), so I was able to install Debian on 2x 640GB WD Caviar Blue HDs in RAID1. SuperMicro BIOS update to the latest versionīut I had no luck. disabled EVERY single (and all together) components on the board (NICs (BOOT ROMs), Serial Port, onboard Storage) "Slot 0 HP Smart Array P410 Initializing \\\"īut I don't get any message how to enter the setup (F8 - I know), once this message is off the screen, the system does a reboot. What I get is the initialization message: I just received the RAID controller 2 days ago and tried to enter the setup. 16GB ECC RAM (4x4GB Kingston DDR3-1333) For my new fileserver, I bought the following hardware: